Seismic Stability Modification Requirements for Pineview Dam
Pineview Dam is located 8 km upstream from Ogden, Utah, and about 8 km from the Wasatch Fault Zone. Preconstruction information and construction records available at the outset of the...
Discontinuities, Rock Deformation and Fluid Flow Around Emplacement Rooms
One of the major concerns for the design of the potential nuclear waste repository at Yucca Mountain is how to identify the fast flow paths and how to minimize the flow of the fast paths....
Open Channels in Fractures Maintained by Deposition and Erosion of Colloids
Colloids initially suspended in the water in fractures can deposit onto the fracture surfaces, and will partially or fully clog the fracture. The amount of clogging will depend on whether...
Geometric Analyses of Alternative Models of Faulting at Yucca Mountain, Nevada
Realistic cross section tectonic models must be retrodeformable to geologically reasonable pre-deformation states. Furthermore, it must be shown that geologic structures depicted on cross...
A Rezoning Procedure for Finite Element Analysis of Rubber-like Materials
In this paper, we propose a rezoning procedure for finite element analysis of rubber-like materials. Rezoning procedures connect the distorted mesh and the newly created and undistorted...
Thin-Walled Finite Element for Curved Multicell Box Girders
The generalized Vlasov's thin-walled beam theory was combined with the finite element technique to develop a new curved thin-walled multicell box girder finite element which can model...
A Generalized Three Invariants Cap Model and its Numerical Implementation to Study Soil-Foundation Interaction
This paper presents a modified cap model that is capable of characterizing cyclic stress-strain behavior of soils and describing variation of shear strength along various stress paths...
Research of the Limit Function About Imperfection and the Approximately Calculating Method of the Internal Forces of Hyperbolic Cooling Tower
The authors use the finite elemental program, which made by themselves and makes use of finite element method with rotational shell, to calculate the deformation in hyperbolic cooling...
Study of a Computer System for Evaluation of Bearing Wall Stresses in Structural Planning ? Reasoning by Neural Network
This report proposes a reasoning system for bearing shear wall stresses in the ultimate state by using geometrical data of buildings and shear walls at the initial stage of aseismic structural...
A Numerical Procedure to Compute Bearing Capacity of Shallow Foundations
A simple numerical procedure of calculation of bearing capacity of shallow foundation is proposed. This procedure employs the Terzaghi-Prandtl model of general shear failure. In this paper,...
Consolidation Settlement Potential in South Louisiana
Primary consolidation is an important cause of wetland loss in active and recently abandoned deltaic plains in south Louisiana. Argillaceous and organic facies are most subject to reduction...
Subsidence Properties of Holocene Sediments: S. La.
As part of a comprehensive USGS-sponsored study of processes that drive subsidence and wetland loss in south Louisiana, two continuously cored deep borings (60 m and 72 m) were acquired...
Friction Factors in Coastal Flooding
As the world's coastal zones are being developed and the coastal population increases, coastal flooding, or rather the prediction of its extent and frequency of occurrence, becomes a more...
A Model of Mixing in a Stratified Tidal Flow
We will describe a simple model of vertical mixing in a stratified tidal flow that might be observed in shallow estuary like San Francisco Bay. The model flow is driven by a specified...
Density Currents in Pollutant Transport and Mixing
A buoyant spreading model for the current-advected plume is formulated including several distinct mechanisms: convective spreading, interfacial friction spreading, entrainment at the density...
Computation of Flow Past a Cylinder Mounted on a Flat Plate
The surface shear stress distribution in the vicinity of a circular cylinder - mounted normal to a rigid flat plate - produced by the three-dimensional flow past it, is investigated numerically...
A Model for Vertical Transport at a Sheared Density Interface
A physically based model for vertical mixing and transport at a sheared density interface is presented, based on high-resolution measurements from laboratory experiments. It is found that...
Selective Withdrawal in a Rotating Stratified Fluid
In this paper we consider the axisymmetric flow of a rotating stratified fluid into a point sink. Linear analysis of the initial value problem of flow of a linearly stratified fluid into...
Fractal Dimension of Aggregated Sediments
Cohesive sediment dynamics in estuarine systems are strongly affected by particle aggregation and flocculation. These processes are mainly controlled by the Brownian motion, flow turbulence...
Shape Effect on Bed-Load Transport in Pipes
The nature of part-full flows in pipe sewers produces different channel shapes resulting in non-uniform shear stress distribution on the wetted perimeter. New experimental data were utilized...
Return to search